9.4. PCI Test FunctionΒΆ

Author:

Kishon Vijay Abraham I <kishon@ti.com>

Traditionally PCI RC has always been validated by using standard PCI cards like ethernet PCI cards or USB PCI cards or SATA PCI cards. However with the addition of EP-core in linux kernel, it is possible to configure a PCI controller that can operate in EP mode to work as a test device.

The PCI endpoint test device is a virtual device (defined in software) used to test the endpoint functionality and serve as a sample driver for other PCI endpoint devices (to use the EP framework).

The PCI endpoint test device has the following registers:

  1. PCI_ENDPOINT_TEST_MAGIC

  2. PCI_ENDPOINT_TEST_COMMAND

  3. PCI_ENDPOINT_TEST_STATUS

  4. PCI_ENDPOINT_TEST_SRC_ADDR

  5. PCI_ENDPOINT_TEST_DST_ADDR

  6. PCI_ENDPOINT_TEST_SIZE

  7. PCI_ENDPOINT_TEST_CHECKSUM

  8. PCI_ENDPOINT_TEST_IRQ_TYPE

  9. PCI_ENDPOINT_TEST_IRQ_NUMBER

  • PCI_ENDPOINT_TEST_MAGIC

This register will be used to test BAR0. A known pattern will be written and read back from MAGIC register to verify BAR0.

  • PCI_ENDPOINT_TEST_COMMAND

This register will be used by the host driver to indicate the function that the endpoint device must perform.

Bitfield

Description

Bit 0

raise legacy IRQ

Bit 1

raise MSI IRQ

Bit 2

raise MSI-X IRQ

Bit 3

read command (read data from RC buffer)

Bit 4

write command (write data to RC buffer)

Bit 5

copy command (copy data from one RC buffer to another RC buffer)

  • PCI_ENDPOINT_TEST_STATUS

This register reflects the status of the PCI endpoint device.

Bitfield

Description

Bit 0

read success

Bit 1

read fail

Bit 2

write success

Bit 3

write fail

Bit 4

copy success

Bit 5

copy fail

Bit 6

IRQ raised

Bit 7

source address is invalid

Bit 8

destination address is invalid

  • PCI_ENDPOINT_TEST_SRC_ADDR

This register contains the source address (RC buffer address) for the COPY/READ command.

  • PCI_ENDPOINT_TEST_DST_ADDR

This register contains the destination address (RC buffer address) for the COPY/WRITE command.

  • PCI_ENDPOINT_TEST_IRQ_TYPE

This register contains the interrupt type (Legacy/MSI) triggered for the READ/WRITE/COPY and raise IRQ (Legacy/MSI) commands.

Possible types:

Legacy

0

MSI

1

MSI-X

2

  • PCI_ENDPOINT_TEST_IRQ_NUMBER

This register contains the triggered ID interrupt.

Admissible values:

Legacy

0

MSI

[1 .. 32]

MSI-X

[1 .. 2048]